-
sethsimmons
Is there a way to only make monerod when running make release-static?
-
iDunk
^C after cmake completes config, make -C build/Linux/branch/release daemon
-
sethsimmons
thanks
-
iDunk
Or just make -C build/Linux/branch/release daemon if not building from a clean state.
-
sethsimmons
<iDunk "^C after cmake completes config,"> Is there a way to do this non-interactively?
-
sethsimmons
Trying to save some time on Docker image builds and don't want any binaries except monerod
-
luigi1111w
.merges
-
xmr-pr
6975 6989 7112 7113 7119 7137 7149 7204 7236 7240 7245 7260 7295
-
kayront
anyone else getting very chatty "SYNCHRONIZED OK" messages? 9 in the last 1.5min for me
-
selsta
kayront: not here but I run the ban list
-
kromgrul
nnedmoney90: Let me quote your hero. 'How do I ban FUK? AAAHHHH I don't remember. youtube.com/watch?v=mdLfkhxIH5Q Keep tryin' champion.
-
kayront
selsta: me too, albeit a somewhat outdated one. would that (the messages) be a symptom of misbehaving peers?
-
selsta
I don't know as I don't see them on my node yet.
-
guest-random1124
Hi there, monero blockchain pruning with the tool takes very long. How can i built in some kind of progress display in the prune function in blockchain_prune.cpp?
-
guest-random1124
I created a file where copy_table actions till properties were done, but prune() takes very long
-
selsta
guest-random1124: it generally is recommended to sync from scratch with pruning enabled
-
selsta
it will most likely be quicker than pruning afterwards
-
guest-random1124
Well but i already have a complete blockchain
-
guest-random1124
Complete full blockchain
-
guest-random1124
Complete sync took a whole week. I do not want to repeat that again
-
Mmmmmmmmmm
A whole week =#
-
Mmmmmmmmmm
Are you writing down the blockchain on paper?
-
guest-random1124
Haha sometimes I have the feeling like that. My notebook is from 2016. not the newest hardware but i also think it should not take that long
-
guest-random1124
When I sync it starts very fast, but till 60% it gets slower and slower
-
guest-random1124
Sry was disconnected
-
guest-random1124
Please repeat if messages during disconnect
-
Mmmmmmmmmm
Why don't you use a remote-node?
-
guest-random1124
Well I want to contribute the network. But machine utilization is more than I thought
-
moneromooo
You're best off resyncing. The in-place pruning is inefficient enough with large databases that resyncing is the best option.
-
moneromooo
It used to be OK when the db was smaller. Not the case anymore.
-
guest-random1124
@moneromooo i do not use in place pruning. I use the tool, is it very long running anyway?
-
guest-random1124
If I understand you right the pruning tool is not good anymore?
-
gingeropolous
the pruning tool is good. it just works best if its enabled from the start
-
gingeropolous
if you prune *after* synchronizing, the tool has to do more work than if you did it during synchronization guest-random1124
-
guest-random1124
Ok. But why?
-
guest-random1124
Network connection is slower than hard drive